Strain - gauge load cell or force transducer , minimum load impedance 320r
2.
Allowable load impedance
3.
Beam loading impedance
4.
Antenna load impedance
5.
Technically , the damping factor is the specified load impedance ( in use , that ' d be the speaker system ) divided by the amplifier ' s output impedance
6.
In this paper , it introduces an automatic impedance matching system that can accomplish matching with the dynamic load impedance in highpower microwave system
7.
Technically , the damping factor is the specified load impedance ( in use , that ' d be the speaker system ) divided by the amplifier ' s [ i ] output impedance [ / i ]
8.
The sinusoidal voltage and current distribution on the line of each frequency component is obtained by the phasor equation for the transmission line and the source and load impedances
9.
A pulldown resistor to the negative rail will allow the output to approach that rail ( provided the load impedance is high enough , or is also grounded to that rail ) , but only slowly
10.
We can also see that because damping factor is a ratio that requires the load impedance to compute , it must be stated against some known impedance to be meaningful
मोबाइल